This section will help you specify the data for connecting drivers, some restrictions or opportunities for driver terminals.
In the SCAT Admin Panel -> Settings -> Server Settings -> Connections.
- Minimum version for Android
- Android latest version
- Reserve server address specify old IP;
- Server address specify new IP;
- In the SCAT admin panel -> Settings -> Commands -> Reboot server -> Run;
- While working on the old IP; In the SCAT admin panel -> Drivers -> Drivers -> edit driver, change driver password, save and scan driver settings as when hiring.
This will overwrite the driver's card and he will immediately have 2 IPs: new and old.
So you slowly reconfigure all the drivers and later switch the server to a new IP - the drivers will continue to work without even noticing the reconnection.
Of course, it is better to use domain to connect drivers in the future.
⚠️ Pay attention!
**1. Standard port for Drivers' Terminals: 1050, if yours is different, then you need to specify your port in the Reserved Server Address;
- If the router changes, then it is necessary to perform port forwarding. SCAT Technical Support can help you with this.**
¶ You have prepaid Settlement Groups. How to add confirmation to open a shift, and not just by opening a terminal:
- Request to open a shift
- Check device ID
⚠️ Pay attention!
In the SCAT software package, one connection with the server is allocated per driver, several devices connected at the same time on one driver will give a permanent failure in both devices at once